Instructions / Assembly

ASSEMBLY
IMPORTANT ASSEMBLY INFORMATION
A Phillips Head screw driver is needed to
assemble trampoline. However, a
screwdriver is not provided.
Assembly requires two persons. Keep
children away from the trampoline
until it is fully assembled.
Use gloves to protect your hands from pinch
points during assembly.
The assembly steps refer to parts by their descrip-
tions and key numbers (see the PART LIST on
page 9). If a part is missing, see ORDERING
REPLACEMENT PARTS on page 9 .
TRAMPOLINE PLACEMENT
1. Place the trampoline on a level surface
before use.
3. Use the trampoline in a
well-lit
indoor or shady areas.
4. Secure the trampoline
against
unauthorized and unsupervised use.
5
. Remove any obstructions from beneath the
trampoline.
4
WARNING!
Please read all of the directions prior to assembly.
Inspect the trampoline to make sure all parts are included. If any worn, defective or
missing parts are found, please contact customer service immediately.
Make sure you wear gloves to protect your hands from pinch point and sharp point during installation.
Be careful where you place your hands; the springs and frame joints can pinch.
Check all screws for tightness and tighten up if loose.
Check all sharp edges and replace when required.
1.
2
4
Smaller end
T-connector+Welded tube
2.
1
1
3
3
3
3
4
4
1
1
2
2
T-connector
T-connector
T-connector
T-connector
T-connector+
Welded tube
1
3
10
10
Smaller end
T-connector