Instructions / Assembly

Trampoline Tie Down Anchor Kit

THANK YOU FOR PURCHASE JUMPKING TRAMPOLINE TIE DOWN ANCHOR KIT. PART # ACC-AK

This kit is designed to be used on any round or rectangle trampoline. It has two basic purposes. For certain types

trampolines it will enable the owner to move the trampoline without the vertical leg pieces separating from the

frame. It is also a tie down system for your trampoline. JUMPKING has tried to provide a utilitarian tie down

anchor kit for a broad range of applications. JUMPKING cannot anticipate every situation or condition where

this kit. JUMPKING does not state, grant or imply any guarantees as to performance or appropriateness of

this JUMPKING Tie Down Anchor Kit, or any of its components, in any application whatsoever.

Your kit should contain:

(4) Four tie down straps

(4) Four 13” auger stakes

JUMPKING

3970 Lindbergh Drive

Addison, TX 75001

Customer Hot Line: 1-877-927-8777 (8am to 5pm)

(Central Standard Time)

www.jumpking.com

INSTALLATION

Make sure the area is free of underground utilities (electrical, gas, phone, water, sprinkler) before installing the

auger stakes. The installation of this kit should be performed by an adult.

The following procedures primarily apply to round trampolines with (4) four support structures.

Each tie down strap consists of two loop straps that are joined with buckles. The larger loop goes around the

toprail and under the leg bottom. The smaller loop goes through the auger stake “eye” and ties the trampoline

to the ground.

PAGE 1
Trampoline Tie Down Anchor Kit THANK YOU FOR PURCHASE JUMPKING TRAMPOLINE TIE DOWN ANCHOR KIT. PART # ACC-AK This kit is designed to be used on any round or rectangle trampoline. It has two basic purposes. For certain types trampolines it will enable the owner to move the trampoline without the vertical leg pieces separating from the frame. It is also a tie down system for your trampoline. JUMPKING has tried to provide a utilitarian tie down anchor kit for a broad range of applications.
PAGE 2
Install an auger stake at the mid point of each leg, about 6 inches from the outside of the leg base, by rotating the stake and pushing it into the ground. The ground should be soft, and it may be necessary to pre-soften this area with some water before beginning. A tool, such as a large screwdriver may be placed through the eye of the stake to form a “T” handle to assist in turning the stake. We recommend that gloves be worn during this process. 1.