User Manual

Deviation User Manual for Jumper T8SG, Release 5.0

11.3. Using a Trim as a Virtual Switch

Now go to the ‘Mixer’ page, and enter the configuration for the specified Virtual Channel (Virt1 in our

example)

Set the mixer-type to ‘Complex’, set the ‘src’ to the current virtual channel (‘Virt1’), set the curve to ‘1-to-

1’ (Do NOT use ‘Fixed’), set the scale to ‘0’, and finally enable the ‘Trim’ button.

You can now use the virtual channel (‘Virt1’) like any other switch input. When the virtual switch is active,

the virtual channel will have a value of 100, otherwise it will have a value of -100.

Note: If you use the virtual channel as a ‘Src’ (as opposed to a ‘Switch’) make sure that ‘trim’ is disabled

for that mixer, otherwise the trim will be applied twice.