User Manual

Deviation User Manual for Jumper T8SG, Release 5.0

11.1. Setting up a Buddy-Box

a Deviation slave transmitter with a Deviation Master configured for ‘Stick’ mode (see above), there should

be no mixing done in the slave transmitter.

11.2 Setting Up FPV or Other External Inputs

Deviation has the ability to use PPM input signals from an external source (such as an FPV setup). To

configure this mode, set the PPM In mode to ‘Extend’ in section Model setup (Std & Adv GUI).

Once enabled, press ‘ENT’ on the PPM In spin-box to configure the additional inputs.

Configuration options:

• Center PW: Defines the pulse-width for a centered input (in µsec).

• Delta PW: Defines the difference in pulse-width (from the center value) to reach min/max servo

throw • Num Channels: Defines the number of channels to input (generally no more than 8 can be

supported)

11.3 Using a Trim as a Virtual Switch

Deviation has the capability to create virtual switches to supplement the mechanical switches of the

transmitter. This capability is only available when using the Advanced GUI. There are 3 types of switches

available:

• Momentary: The switch will be active only as long as the trim button is held

• Toggle: The switch will toggle from on-to-off or off-to-on each time the trim button is pressed

• On/Off: The Trim+ button will turn the switch on, and the ‘Trim-‘ button will turn it off-to-on

To setup a virtual switch, start by selecting the trim from the ‘Trim’ page, and entering the trim-setup page.

See Trims and Virtual Inputs (Std & Adv GUI)