User Manual

Deviation User Manual for Jumper T8SG, Release 5.0
84 Chapter 11. Advanced Topics
Channel: In channel mode, each input channel is mapped to an output channel on the instructor’s
transmitter. In this mode, the student’s transmitter should do all necessary mixing to control the model.
Care must be taken to ensure that the instructor and student transmitters are configured identically,
otherwise, the model may not react well when switching between instructor and student control.
Options configurable on both Trainer Cfg pages:
• Center PW: Defines the time (in µsec) of the pulse that the student’s transmitter transmits to
represent centered servo position. If this number doesn’t match the students transmitter, the servos
will not be centered
• Delta PW: Defines the width of the pulse (measured from center) sent by the student’s transmitter
to define max servo throw. If this value is incorrect, the servos will not achieve full range (or will
travel too much)
• Trainer Sw: Defines the switch that enables the student to take control of the model
• PPM1...PPM8: Defines the mapping (either channel or input) from the student’s transmitter to the
instructor’s
11.1.2 Slave Mode
Slave mode is configured by choosing ‘PPM’ as the protocol in section Model setup (Std & Adv GUI).
Pressing ‘ENT’ on the Protocol spin-box will enable setting the output options. See section Protocol:
USBHID for configuration. Note that Deviation will send the channel output data through the PPM. To use