User Manual

Deviation User Manual for Jumper T8SG, Release 5.0
80 Chapter 10. Protocols
Both sticks bottom left starts accelerometer calibration on H8 3D, or headless calibration on H20.
Both sticks bottom right starts accelerometer calibration on H20 and H11D.
10.36 Protocol: *MJXq
The MJXq protocol supports the MJX quadcopters. It also has format options for Weilihua WLH08, EAchine
E010 and JJRC H26D / H26WH. NOTE: This protocol requires the addition of an ‘NRF24L01’ hardware
module to function. See the following document for more information:
http://www.deviationtx.com/wiki/#hardware_modifications
The MJXq protocol supports 12 channels and only supports auto-binding.
The first four channels are Aileron, Elevator, Throttle and Rudder.
Channel 5 controls LEDs, or arm if H26WH format is selected.
Channel 6 controls Flip mode.
Channel 7 controls the still camera
Channel 8 controls the video camera.
Channel 9 controls headless mode.
Channel 10 controls RTH mode
Channel 11 controls autoflip (X600 & X800 formats) or camera pan
Channel 12 controls camera tilt
10.37 Protocol: *PPM
The PPM protocol is used to output PPM on the trainer port. It will disable all radio transmission. PPM is
useful for connecting to simulators, or other radio-modules that plug into the trainer port. The Fixed ID
has no effect, and there is no binding associated with this protocol.
Options configurable on the PPM page: