User Manual

Deviation User Manual for Jumper T8SG, Release 5.0
78 Chapter 10. Protocols
The Esky150 protocol supports up to 7 channels, and does not support auto-binding. If Fixed ID is set to
None, a transmitter-specific ID is used instead. It is necessary to manually bind each model before the first
use.
Channels 1-4 are throttle, aileron, elevator and rudder. Channel 5 is flight mode (1 bit switch with only two
states). Channel 6 is not yet used on any of the tested models. Channel 7 is a 2 bit switch (4 states).
It is important if you have a 4 channel model, to configure that your model only has 4 channels, otherwise
the throttle values can go crazy.
10.31 Protocol: *Esky
Needs to be completed. NOTE: This protocol requires the addition of an ‘NRF24L01’ hardware module to
function. See the following document for more information:
http://www.deviationtx.com/wiki/#hardware_modifications
The Esky protocol supports up to 6 channels, does not support auto-binding. If Fixed ID is set to None, a
transmitter-specific ID is used instead. It is necessary to manually bind each model before the first use.
10.32 Protocol: *BlueFly
The BlueFly protocol is used with the Blue-Fly HP100. It has not been tested with any other models. NOTE:
This protocol requires the addition of an ‘NRF24L01+’ hardware module to function. Note the “plus”
version of the nRF device is required to support the 250kbits/s data rate. See the following document for
more information:
http://www.deviationtx.com/wiki/#hardware_modifications
The BlueFly protocol supports up to 6 channels, does not support auto-binding. If Fixed ID is set to None,
a transmitter-specific ID is used instead. It is necessary to manually bind each model before the first use.
10.33 Protocol: *CX10
The CX10 format supports the Cheerson CX10 quadcopter. NOTE: This protocol requires the addition of an
‘NRF24L01’ hardware module to function. See the following document for more information:
http://www.deviationtx.com/wiki/#hardware_modifications
The CX10 protocol supports 9 channels and only supports auto-binding. The protocol stays in bind mode
until successful. The first four channels are Aileron, Elevator, Throttle and Rudder.
Channel 5 is Rate except on the CX-10A, where it is headless mode.
Channel 6 is flip mode.
The DM007 format also uses channel 7 for the still camera, channel 8 for the video camera and channel 9
for headless mode.