User Manual

Deviation User Manual for Jumper T8SG, Release 5.0
76 Chapter 10. Protocols
• Channel 9 turns headless mode on/off
• Channel 10 engages the return-to-home feature
10.25 Protocol: *FY326
This protocol is used on FY326 red board.
NOTE: This protocol requires the addition of an ‘NRF24L01+’ hardware module to function. Note the “plus”
version of the nRF device is required to support the 250kbits/s data rate. See the following document for
more information: http://www.deviationtx.com/wiki/#hardware_modifications
The first four channels represent Aileron, Elevator, Throttle, and Rudder. Additional channels control
special functions:
• Channel 5 is unused
• Channel 6 enables the flip function
• Channel 7 is unused
• Channel 8 is unused
• Channel 9 turns headless mode on/off
• Channel 10 engages the return-to-home feature
• Channel 11 initiates calibration
10.26 Protocol: *CFlie
The CFlie protocol is used on the CrazyFlie nano quad. It has not been tested with any other models. NOTE:
This protocol requires the addition of an ‘NRF24L01+’ hardware module to function. Note the “plus”
version of the nRF device is required to support the 250kbits/s data rate. See the following document for
more information:
http://www.deviationtx.com/wiki/#hardware_modifications
The CFlie protocol supports up to 4 channels, does not support auto-binding. If Fixed ID is set to None, a
transmitter-specific ID is used instead. It is necessary to manually bind each model before the first use.
10.27 Protocol: *H377
The H377 protocol supports the NiHui H377 6 channel helicopter. It has not been tested with any other
models. NOTE: This protocol requires the addition of an ‘NRF24L01’ hardware module to function. See the
following document for more information:
http://www.deviationtx.com/wiki/#hardware_modifications