User Manual

Deviation User Manual for Jumper T8SG, Release 5.0
75
The eighth channel starts/stops video recording on each positive transition.
The ninth channel enables headless mode when positive.
10.23 Protocol: *Hontai
This protocol is used on Hontai models F801 and F803.
NOTE: This protocol requires the addition of an ‘NRF24L01+’ hardware module to function. Note the “plus”
version of the nRF device is required to support the 250kbits/s data rate. See the following document for
more information: http://www.deviationtx.com/wiki/#hardware_modifications
10.22. Protocol: *SymaX
The first four channels represent Aileron, Elevator, Throttle, and Rudder. Additional channels control
special functions:
• Channel 5 is unused
• Channel 6 enables the flip function
• Channel 7 takes a picture on positive transition through zero
• Channel 8 turns video on/off on positive transition
• Channel 9 turns headless mode on/off
• Channel 10 engages the return-to-home feature
• Channel 11 initiates calibration
10.24 Protocol: *Bayang
This protocol is used on BayangToys X6, X7, X8, X9, JJRC/Eachine H8, H10, and JJRC JJ850.
NOTE: This protocol requires the addition of an ‘NRF24L01+’ hardware module to function. Note the “plus”
version of the nRF device is required to support the 250kbits/s data rate. See the following document for
more information: http://www.deviationtx.com/wiki/#hardware_modifications
The first four channels represent Aileron, Elevator, Throttle, and Rudder. Additional channels control
special functions:
• Channel 5 is unused
• Channel 6 enables the flip function
• Channel 7 captures single photo on positive transition
• Channel 8 starts/stops video recording on positive transition