User Manual

Deviation User Manual for Jumper T8SG, Release 5.0

http://www.deviationtx.com/wiki/#hardware_modifications

The V202 protocol supports up to 11 channels, does not support auto-binding. If Fixed ID is set to None, a

transmitter-specific ID is used instead. It is necessary to manually bind each model before the first use.

The 1 st 4 channels represent Aileron, Elevator, Throttle, and Rudder. Additional channels control the

quadracopter special functions:

• Channel 5 controls the blink speed

• Channel 6 enables ‘flip’ mode

10.16. Protocol: *Skyartec

• Channel 7 takes still pictures

• Channel 8 turns video on/off

• Channel 9 turns headless mode on/off

• Channel 10 causes the x axis to calibrate

• Channel 11 causes the y axis to calibrate

If JXD-506 format is selected, channels 10-12 are used for:

• Channel 10 start/stop

• Channel 11 emergency stop

• Channel 12 gimbal control

Also, models compatible with this format require the throttle stick to be centered before arming.

10.19 Protocol: *SLT

The SLT protocol is used to control TacticSLT/Anylink receivers. NOTE: This protocol requires the addition

of an ‘NRF24L01’ hardware module to function. See the following document for more information:

http://www.deviationtx.com/wiki/#hardware_modifications

The SLT protocol supports up to 6 channels, and only supports auto-binding. The fixed ID can be used, but

does not prevent auto-binding during power-on.

10.20 Protocol: *HiSky

The HiSky protocol is used to control HiSky brand models along with the WLToys v922 v955 models. NOTE:

This protocol requires the addition of an ‘NRF24L01’ hardware module to function. See the following

document for more information:

http://www.deviationtx.com/wiki/#hardware_modifications