User Manual

Deviation User Manual for Jumper T8SG, Release 5.0
69
10.9. Protocol: *AFHDS-2A
10.10 Protocol: *Hubsan4
The Hubsan4 protocol supports the Hubsan-X4 quadracopter and the Estes Proto X (but not the Proto X
SLT). No other models have been tested with this protocol. NOTE: This protocol requires the addition of
an ‘A7105’ hardware module to function. See the following document for more information:
http://www.deviationtx.com/wiki/#hardware_modifications
The Hubsan4 protocol supports up to 7 channels, and only supports auto-binding. The fixed ID can be used,
but does not prevent auto-binding during power-on. The 1 st 4 channels represent Aileron, Elevator,
Throttle, and Rudder. Additional channels control the quadracopter special functions:
• Channel 5 controls the LEDs
• Channel 6 enables ‘flip’ mode
• Channel 7 Turns video on/off
Options configurable on the Hubsan page:
• vTX MHz: Defines the frequency used by the Hubsan H107D video transmitter (Requires a 5.8GHz
receiver capable of receiving and displaying video).
• Telemetry: Enable receiving of model battery voltage.
10.11 Protocol: *Joysway
The Joysway protocol supports the Joysway Caribbean model yacht, and the J4C12R receiver used in the
Joysway Orion, Explorer, Dragon Force 65 model yachts and Force2 60 model catamaran. No other models
or receivers have been tested with this protocol, including air versions of the J4C12R. NOTE: This protocol
requires the addition of an ‘A7105’ hardware module to function. See the following document for more
information:
http://www.deviationtx.com/wiki/#hardware_modifications
The Joysway protocol supports up to four channels, does not support auto-binding, but will bind whenever
a receiver requests binding. If Fixed ID is set to None, a transmitter-specific ID is used instead. It is
necessary to bind each model before the first use.
The first channel normally controls the sheets and the second channel the rudder, but this may vary from
model to model.