User Manual

Deviation User Manual for Jumper T8SG, Release 5.0
68 Chapter 10. Protocols
The Flysky protocol also supports WLToys extensions to the protocol. These are accessed by pressing the
Protocol spin-box when Flysky is shown:
V9x9: Enables the extensions for the WLToys V939, V949, V959, v969, etc quadcopters.
• Lights are controlled by Channel 5
• Video is controlled by Channel 6
• Camera is controlled by Channel 7
• Flip is controlled by Channel 8
V6x6: Enables the extensions for the WLToys V636 and V686 quadcopters.
• Lights are controlled by Channel 5 • Flip is controlled by Channel 6
• Camera is controlled by Channel 7
• Video is controlled by Channel 8
• Headless mode is controlled by Channel 9
• RTH mode is controlled by Channel 10
• X and Y calibration are controlled by channels 11 and 12, respectively.
V912: Enables the extensions for the V912, V913 and V915 helicopters
Note that if these channels are assigned to a switch, turning the switch on toggles the state, and turning
the switch off has no effect. Thus to turn the lights on, flip the switch assigned to Channel 5 from off to on.
Flipping the switch back to off has no effect. Flipping the switch back on now turns the lights back off.
10.9 Protocol: *AFHDS-2A
The AFHDS-2A protocol is used to control Turnigy/Flysky AFHDS 2A receivers. NOTE: This protocol requires
the addition of an ‘A7105’ hardware module to function. See the following document for more information:
http://www.deviationtx.com/wiki/#hardware_modifications
The AFHDS-2A protocol supports up to 12 channels, and requires manual-binding. The receiver must be
bound manually one-time using the ‘Bind’ button, after which it should stay bound.
Options configurable on the AFHDS-2A page:
• Outputs: Sets desired outputs type on the receiver, PWM+IBUS, PPM+IBUS, PWM+SBUS or
PPM+SUBS
• Servo Hz: Sets receiver PWM refresh rate between 50 Hz and 400 Hz
Partial telemetry support, only receiver voltage and RSSI in dB are supported for now.