User Manual

Deviation User Manual for Jumper T8SG, Release 5.0
66 Chapter 10. Protocols
The following fields are available in DSM2 Telemetry. Note that a dedicated telemetry module and
additional sensors are needed to capture this data
• FadesA/B/L/R: The number of times each antenna has received a weak signal. Ideally these numbers
should all be similar, indicating even reception to each antenna
• Loss: The number of times complete signal loss (dropped frame) occurred
• Holds: The number of times the receiver entered fail-safe mode due to loss of signal
• Volt1/2: Battery voltage for receiver and an external source
• RPM: Engine/Motor speed
• Temp: Temperature from external temperature sensor
• GPS Data: Current position, speed and altitude from GPS module