User Manual

Deviation User Manual for Jumper T8SG, Release 5.0
9.8. Standard GUI Menu items 57
9.8.5 Swash Configuration
The Swash configuration page configures the swash type. More information about swash-types can be
found in section Swash Mixing. The settings on this page are equivalent to those on the model
configuration page (see Model setup (Std & Adv GUI)), and configuration for both pages is provided below.
Helicopter configuration
from 'Model Config'
page
Swash configuration
from Standard GUI
The available SwashType values are:
• None/1Servo: Used For FBL. Mixing occurs in receiver
• 120/3Servo 120: 120-degree swash
• 120x/3Servo 120x: 120 degrees swash (alternate config)
• 140/3Servo 140: 140 degree swash
• 90/3Servo 90: 90 degrees swash
The ELE Mix, AIL Mix, and PIT Mix are scaling factors applied to the input sticks before mixing is done.
These can be used to adjust for different linkage lengths or different servo throws. The allowed range is -
100 to 100 with a default of 60. Note that setting these values too large can result in too much servo throw
and make the model unresponsive to stick control.
9.8.6 Throttle Curve