User Manual

Deviation User Manual for Jumper T8SG, Release 5.0
56 Chapter 9. Model menu
The dual-rate and expo page allows configuration of curves for the Aileron, Rudder, and Elevator channels.
Up-to 3 rates can be configured for each channel, and either a scaled-linear or exponential curve can be
selected for each. The number of settings depends on the switch assigned to the dual-rates function on
the Switch Assignment page (see Switch Assignment)
9.8.3 Sub-trim Adjustment
The sub-trim adjust page allows setting the zero-point of the servos for each channel. This is equivalent to
the ‘Subtrim’ setting on the Channel Configuration sub-page of the Mixer menu when using the Advanced
GUI (see Channel configuration). Acceptable values range from -50 to +50 in 0.1 increments.
9.8.4 Servo Travel Adjust
The servo-travel adjust page configures the maximum positive/negative travel of each servo. This is
equivalent to the ‘Scale+’ and ‘Scale-’ settings on the Channel Configuration sub-page of the Mixer menu
when using the Advanced GUI (see Channel configuration). Acceptable values for Down are from -175 to -
1 and Up values range from +1 to +175. The default values are -100 and +100 respectively.