User Manual

Deviation User Manual for Jumper T8SG, Release 5.0
9.8. Standard GUI Menu items 55
6. Throttle curves: Throttle curve setup
7. Pitch curves: Pitch curve setup
8. Throttle hold: Throttle-hold configuration
9. Gyro sense: Gyro-sense configuration
10. Swash: Swash Setup
11. Fail safe: Fail-Safe configuration
12. Switch assignment: Assign switch controls
13. Timers: Timer configuration (See section Timers (Std & Adv GUI))
14. Telemetry config: Configure telemetry alarms (See section Telemetry config (Std & Adv GUI))
15. Datalog: Configure telemetry logging (See section Datalog (Std & Adv GUI))
16. Main page config: Configure main page display (See section Main page config (Std & Adv GUI))
9.8.1 Servo Reverse
The servo reverse page allows quickly setting each channel to work in either normal or reversed mode.
These settings are equivalent to the ‘Reverse’ setting on the Channel Configuration sub-page of the Mixer
menu when using the Advanced GUI (see section Channel configuration)
9.8.2 Dual-Rate/Expo setting