User Manual

Deviation User Manual for Jumper T8SG, Release 5.0
45
9.5 Trims and Virtual Inputs (Std & Adv GUI)
The trim page allows assigning the trim buttons and trim step, as well as configuring buttons to work as
virtual inputs (see Using a Trim as a Virtual Switch). It is accessed from the main menu via ‘Model menu’
followed by ‘Trims’.
If the ‘Input’ field is set to an input stick, then the trim can be applied as part of the mixer, and will operate
as a typical trim control. If the ‘Input’ field is set as a channel or virtual-channel output, the value is applied
directly to the channel output. In this case, the selected ‘Trim +’ and ‘Trim -’ buttons can operate as a
virtual stick to control an output channel.
The trim-step defines how sensitive the trims are to input. The maximum number of trim steps is +/-100.
So a step size of 0.1 will allow a full +/- 10% of trim adjustment on the servo.