User Manual

Deviation User Manual for Jumper T8SG, Release 5.0
44 Chapter 9. Model menu
9.3. Timers (Std & Adv GUI)
The ‘permanent’ timers are similar to an odometer and have their values saved in the model.ini file. They
will maintain their previous value when powering up the transmitter. You can set the timer by using the
‘Set to’ button and reset by pressing the ‘Reset’ button.
9.4 Telemetry config (Std & Adv GUI)
The telemetry configuration page allows specifying alarms when specific telemetry events occur.
• Telemetry: Specify the telemetry input to use for alarm control. The set of values available will
depend on the protocol.
• Equality: Can be ‘>=’ or ‘<=’ indicating whether a value above or below the target causes an alarm.
• Target: The target value for the alarm.