User Manual

Deviation User Manual for Jumper T8SG, Release 5.0
43
9.3 Timers (Std & Adv GUI)
The timer page defines up to 4 available timers. Timers can count either up or down, and can be enabled
either manually from the main screen or by an input trigger (stick or switch).
Available timers are stopwatch, countdown, stopwatch-proportional, countdown-proportional, and
permanent.
Timers can also be optionally configured to be reset via an alternate switch (only when using the Advanced
GUI).
Both proportional timers need an input between 0 and 100 to act correctly. If you use these timer for
throttle a virtual mixer must be used as the input to scale -100 to 100 values into 0 to 100.