User Manual

Deviation User Manual for Jumper T8SG, Release 5.0
9.2. Mixer (Adv GUI) 41
The reorder page can add new mixers or delete existing ones using the ‘+’ and ‘-’ buttons respectively. A
mixer can also be copied to an existing mixer (overwriting it in the process) by using the ‘Copy To’
functionality.
9.2.9 Available Curves
The following curve functions are supported:
• 1-to-1: Output is equal to the input (not editable).
• Fixed: Output is constant regardless of input (offset editable).
• Min/Max: Output is -100 if input is less than the specified value and 100 otherwise.
• Zero/Max: Output is 0 if input is less than the specified value and 100 otherwise.
• >0: Output matches input when greater than the specified value, and 0 otherwise.
• <0: Output matches the input when less than the specified value, and0 otherwise.
• ABSVAL: Output is the absolute-value of the input (editing the specified value will alter how the absolute-value is
applied)
• EXPO: Apply exponential curve to the input for non-linear response (editable see Curve Editing).
• Deadband: Output will not respond to input values near zero (editable see Curve Editing).
• Multi-point: Curve is based on 3, 5, 7, 9, 11 or 13 user-defined points (editable see Curve Editing).
The default value for any of the offsets in above mentioned curves is 0 (zero). If you change the curve for one
input the offset will be transferred to the new curve if possible.
9.2.10 Curve Editing
The Curve Editor is accessed by selecting the curve spin-box when it is selectable. The 1-1 and Fixed curve types
may not be edited, and the curve-box will not be selectable if one of these curves is currently active.
The Curve editor page will be different depending on which curve is selected. It is not possible to change
the curve type from the curve editor (except when a multi-point curve is selected). Values can be set using
the spin-box or by touching the graph.