User Manual

Deviation User Manual for Jumper T8SG, Release 5.0
9.2. Mixer (Adv GUI) 35
min/max range, it will be clipped to either the min or max value as appropriate. Default is -150 for Min
Limit and +150 for Max Limit. Maximum setting is -250 to 0 for Min Limit and 0 to 250 for Max Limit.
Scale-/Scale+: These values define a final scalar to adjust the servo throw. Allowed entries are between 1
and 250. When you alternate Scale+ Scale- will be changed in the same way. If Scale- has been set to a
different value than Scale+ both data will act separately until you set them to the same value again.
Subtrim: Adjust servo zero position. The available range is between -50.0 and +50.0 in 0.1 increments.
Speed: Adjust maximum servo speed. Zero is disabled (fastest), Range is between 1 (slowest) and 250 (fastest). Servo
Example: A value of 60 will give a speed of 60degrees per 100msec which is equivalent to center-to max in 100msec.
Most servos are rated at ~60degrees/0.1sec, so a speed > 60 will have no affect on most servos. A value of 30 should
be approx twice as slow as a typical servo.
9.2.3 Virtual channel configuration
If you press ENT on a virtual channel a keyboard screen is shown where you may edit the default name. You
can use L/R/UP/DN buttons followed by ‘ENT’ to select.
9.2.4 Simple Mix Type