User Manual

Deviation
User Manual for Jumper T8SG, Release 5.0
34 Chapter 9. Model menu
The Channel reorder page allows moving mixer definitions between channels as well as duplicating
channel configurations. Note that the values displayed are the initial channel assignments. Whenever the
page is loaded, the channels will be sequentially ordered representing the current state.
9.2.2 Channel configuration
The Channel configuration provides the ability to configure the final channel outputs. Capabilities such as
channel reverse and fail-safe values are applied here. Also available are controls for end-points, scaling,
sub-trim, and a safety switch (which could be used to ensure that a motor cannot spin-up while working
on a model)
Changes to this page will immediately effect the channel output. Pressing ‘Cancel‘ will restore the shown values
to their last saved state.
Reverse: Reverse the direction of servo rotation
Fail-safe: Specifies a value that the receiver should use when it loses signal from the transmitter. The range
is between -125 and +125 or None. Not all receivers support this capability.
Safety: Specifies a switch that will override all mixers and force the channel output to ‘Safe Val’ when flipped.
Safe Val: If a safety switch is chosen the Safe Val can also be specified. The acceptable range of Safe Val is any
value between -150 and 150.
Min Limit/Max Limit: These values define the minimum and maximum values that the transmitter will ever
send to the receiver (after all scaling, trims and mixer are applied). If a calculated value is outside the