User Manual

Deviation User Manual for Jumper T8SG, Release 5.0
31
Model Type: Set the model-type available options are Heli, Plane and Multi. Helicopter models have an
additional configuration page that can be accessed by clicking the Model type. The options for SwashType
are identical to the ones in Swash Configuration.
If you switch from model type Helicopter this will change the Mixer GUI to Advanced automatically
because the Standard GUI only supports helicopters.
Transmitter Power: Specify the radio output power (when applicable). Available options are 100µW,
300µW, 1mW, 3mW, 10mW, 30mW, 100mW, 150mW.
Note: A stock Devo7e transmits with 7mW. Due to software configuration 150mW will always be displayed.
PPM In: Allows input from the DSC port primarily to control external hardware such as camera motors
from a ‘head tracker’. Secondarily it may be used to enable the transmitter to act as a Master in a buddy-
box setup. Available options are Channel, Stick and Extend.
The Stick and Channel modes are used for buddy-box setup and documentation can be found in chapter
Setting up a Buddy-Box. The Extend mode is used for FPV or external input setup and documentation can
be found in chapter Setting Up FPV or Other External Inputs.
Protocol: Set the type of receiver being used. Note that some protocols have additional options that can
be accessed by pressing the Protocol spin-box when it is active. See section Protocols for more on specific
protocols. Note that a protocol change will disable any currently active protocol and will affect any active
model. To enable the newly chosen protocol, use the Bind/Re-Init button described below.