User Manual

Deviation User Manual for Jumper T8SG, Release 5.0
22 Chapter 8. Transmitter Menu
8.1.4 Timer settings
Prealert time: Time before timer reaches zero to start beeping. Acceptable entries are from 5 seconds to
1 minute in 5 second intervals and may also be turned off.
Prealert intvl: How often to beep before timer reaches zero. Interval may be set from 1 – 60 seconds and
may also be turned off.
Timeup intvl: How often to beep once timer has expired. Interval may be set from 1 – 60 seconds and may
also be turned off.
8.1.5 Telemetry settings
Temperature: Set units to display temperature for telemetry. Available options are Celsius and Fahrenheit.
Length: Set units to display length for telemetry. Selection choices are Meters and Feet.
8.2 Channel monitor
The channel monitor screen allows the user to see the values of each channel as output by the transmitter.
Channels without mixers will not be displayed. Channel output displayed is the value based on minimum
/ maximum values as well as scaling.
Example: A channel scaled from -60 to +60 will only display the range of values from -60 to +60 depending
on the stick position.