User Manual

Deviation User Manual for Jumper T8SG, Release 5.0

8.1. Transmitter config Language: Select an appropriate language for all text.

NOTE: This feature is not available for Devo7e.

Stick mode: Select one of Mode 1-4.

• Mode 1 is common in Europe. Elevator and Rudder on left, Throttle and Aileron on right.

• Mode 2 is common in North America. Throttle and Rudder on left, Elevator and Aileron on right.

• Mode 3 has Elevator and Aileron on left, Throttle and Rudder on right

• Mode 4 has Throttle and Aileron on left, Elevator and Rudder on right

Sticks: Calibrate the range of all analog sticks and dials.

To perform a stick calibration, highlight the Calibrate option and press the ENT button. Follow the on screen

prompts for moving the sticks and confirming with the ENT button.

8.1.2 Buzzer settings

Power On alarm: Select the interval to be notified if your transmitter is on without action. Range is 0 – 60

minutes in 1 minute intervals.

Battery alarm: Set battery voltage at which alarm will sound. The voltage range is 3.30V – 12.00V in 0.01V

increments.

Alarm interval: Set frequency of alarm when battery is low. Alarm intervals can be set from 5 seconds to 1

minute in 5 second intervals. It may also be set to Off.

Buzz volume: Set buzzer volume. Available range is 1 – 10; the buzzer may also be set to None.

Vibration: Enable vibration on alarms, if available.

Power-down alert: Play sound at power-down.

8.1.3 LCD settings

Backlight: Set screen brightness. Acceptable entries are from 1 to 10. It may also be turned off.

Contrast: Set screen contrast. Acceptable entries are from 1 to 10. It may also be turned off.

Dimmer time: Set delay before screen dimming. Times may be set from 5 seconds to 2 minutes in 5 second

intervals. A setting of Off will force backlight to remain on as long as the transmitter is on.

Dimmer target: Set screen brightness when dimmed. Acceptable entries are from 1 to 10 and may also be

turned off.