Manual

37
8 Parameterization
Diagnostics
System command Teach SP1 Teach button in the software to teach
in switching point 1 of the selected
switching channel.
Teach SP2 Teach button in the software to teach
in switching point 1 of the selected
switching channel (for window or two
point mode).
Event setting, auto-calibration er-
ror
False Setting to transmit an event in the
case of an error during auto-calibra-
tion.
Event setting, pollution degree False Setting to transmit an event in the
event the pollution degree is exceed-
ed.
Status display according to IO-Link, NE 107, user-de-
fined
–
Brightness of the status display Eco-mode, medium, high,
maximum
–
Pollution degree Selection list:
low, medium, high (–)
–
Filter time constant Input range:
0 to 100 s (–)
–
Temperature unit °C, °F –
Load default settings (rES) – Reset to default settings.
Parameter Default setting Description
Parameter Default setting Input option
Device status – Shows information about the device
status.
Error counter – Shows information on the number of
registered errors.
System command back-to-box – IO-Link-specific button for resetting
the default settings.
System command locator start – IO-Link-specific button to have the
installed device flash in the plant.
System command locator stop – IO-Link-specific button to have the
device installed in the plant no longer
flash.
Current diagnosis information – Display of current diagnostic mes-
sage.
Last diagnosis information – Display of the last diagnostic mes-
sage.
Simulation mode On, Off Activate or deactivate simulation
mode.
Measured value simulation Input range:
0 to 100 % (–)
Input of a simulated measured value.
Service commands reset all ser-
vice parameters
– Button that resets all service param-
eters listed in the sub-menu.
Service command reset operating
hours
– Button that resets the operating
hours counter.