User Manual

Note: To maintain conformance, the module shall be installed in accordance with the installation
instructions in this data sheet and shall not be modified. When integrating a radio module into a
completed product the integrator becomes the manufacturer of the final product and is therefore
responsible for demonstrating compliance of the final product with the essential requirements
against the RED.
6.4.1 Labeling and User Information requirements
The label on the final product which contains the module must follow CE marking requirements.
6.5 Taiwan
The module has received compliance approval in accordance with the Telecommunications Act.
Customers seeking to use the compliance approval in their product must contact Julius Blum GmbH to
obtain a Letter of Authority.
Integration of this module into a final product does not require additional radio certification provided
installation instructions are followed and no modifications of the module are allowed.
6.5.1 Labeling and User Information requirements
For the module, due to limited module size, the NCC mark and ID are displayed in the data sheet
and/or packaging and cannot be displayed on the module label.
The user's manual must contain below warning (for RF device) in traditional Chinese:
注意 !
依據 低功率電波輻射性電機管理辦法
第十二條 經型式認證合格之低功率射頻電機，非經許 可，
公司、商號或使用者均不得擅自變更頻率、加大功率或 變更原設計
之特性及功能。
第十四條 低功率射頻電機之使用不得影響飛航安全及 干擾合法通信；
經發現有干擾現象時，應立即停用，並改善至無干擾時 方得繼續使用。
前項合法通信，指依電信規定作業之無線電信。
低功率射頻電機須忍受合法通信或工業、科學及醫療用 電波輻射性
電機設備之干擾。
Blum 23.A00L83 RF Module Manual 1.0.2
Page 16 of 17