Manual

Menu functions

Attention:

The following menu point Cont is only adjustable via the

configuration level if the status is „OFF“.

On a unit which is switched on this status is reached by

switching on/off at the mains switch (1).

ACTUAL

SET

Cont - Control mode

0 = internal control

1 = external control (with an external

sensor connected to "N")

10.4. Selecting/exiting the calibration level

+ 2x

Simultaneously press the

"MENUE" key (4.2) and twice

the edit key " " to select the calibration level

the edit key " " to exit the calibration level.

Select the menu items of the calibration level one by one

by pressing simultaneously the menu key and one of the

cursors.

10.5. Calibration

ACTUAL

SET

Ad E - Calibration of external sensor

 Connect a Pt100 sensor to the connector (N), immerse

into the calibration bath. Use a calibration thermometer

and measure the bath temperature.

Adjust the external sensor to this value (example: 20.8 °C).

 Press the setpoint key (E).

Follow the instructions under section 6.3.1. page 27





