Owner manual

Cryo-Compact Circulators

Int. Programmer

>Edit

Delete

Set Clock

Edit Compile profiles

Display sections

Important: Also a running profile can be changed.

See „Edit after start“ page 42

Delete Delete sections

Print Print a programmed profile

Set clock Set the real time on the instrument

Example:

>Edit Profile: 1

Step: 6

Setp: 100.00°C

Time [hh:mm] 01:05

Edit

Compile profiles:

A flashing segment indicates that a number needs to be entered.

Under submenu „Edit Profile“ enter a profile number.

Six profiles may be stored (nos. 0 to 5).

Edit Profile: Profile No.1

Then programme the desired values for each section.

Use the keypad to set section number, target temperature and time

period. Set each entry with enter

Step: Section No. 6

Setpoint: target temperature - 100 °C

Time time period - 1 h:05 minutes

When the program is running, only sections having complete

information for target temperature and time period are considered.

It makes sense, to leave out section numbers in the profile, in order

to use them later for corrections in the profile

Important:

If a time of 00:00 is set for a profile, the profile is continued with the

next section only after the setpoint temperature (±0.2 °C) is

reached.

Example:

Step (No.) 1 3 5 6 9 11 14

Setpoint (°C) 50 50 100 100 80 80 20

Time (h.m) 00:08 00.02 00:10 01:05 00:10 00:05 00:30