Phau Ntawv Qhia

ENGLISH
10
INSTALLATION
Preparation
• Dig a hole in firm ground for the lamp's foundation. The hole should be 25.4 x 25.4 x 14 cm in size
(l x w x d).
• Make sure that the power cord protrudes 13 cm above ground level in the middle of the hole.
• Secure three anchor rods (B) to the triangular support (A).
• Pour 4 cm of ready-mixed cement into the hole. While the cement is wet, position the anchor rods
and triangular support vertically. Pour in the remaining cement up to ground level.
• Check that the heads of the anchor rods protrude so that they fit the base. Fit the lamp when the
cement has set.
Installation
• Pull the power cord through the upper post unit (E) and the lower post unit (D). Mount the lamp (F)
on the post using screws (I4).
• Connect the lamp's power cord to the terminal block (see figure on previous page). Make sure you
connect a brown wire (L = live) to a brown wire, a blue wire (N = neutral) to a blue wire and a
green/yellow wire (earth) to a green/yellow wire.
• Fit the lower post unit to the base using screws (I2).
• Connect the power cord to the terminal block.
• Mount the base on the anchor rods using bolts and washers (I1).
• Adjust the lamp to the height required and then tighten the post units using screws (I3).
MAINTENANCE
Replacing the bulb
• Disconnect from the mains supply.
• Open the upper lamp cover.
• Do not touch the bulb with your bare hands.
• Unscrew the old bulb when it has cooled.
• Carefully screw the new bulb into the bulb holder.
• Put the lamp cover back before switching on the lamp.