Instruction Manual

– 3 –
WARNING :
To protect against possible personal injury due to abrupt start of the machine, be sure to start the
following work after turning the power o󰀨 and ascertaining that the motor is at rest.
(1) Installing the regulator
1) Install regulator (asm.)
❶
on mounting plate
❺
with screw
❷
, spring washer
❸
and nut
❹
which
are supplied with the unit.
2) Attach joint
❻
to inlet
1
. Attach joint
❼
to outlet
2
.
3) Attach mounting plate
❺
on the undersurface of
the table with accessory screws
❽
supplied with
the plate.
4) Connect the
ø
6 air tube to joint
❼
.
* Screw
❷
which is supplied with the unit:
Thread diameter M5; Length: 12 mm
(SM6051202TP)
(2) Adjusting the air pressure
1) The operating air pressure is 0.5 to 0.55 MPa.
Adjust the air pressure using air pressure regulat-
ing knob
❶
of the lter regulator.
2) In the case uid accumulation is observed in
A
section of the lter regulator, turn drain cock
❷
to
drain the uid.
Decrease Increase
❶
❷
A
❷
❶
❺
❼
❻
❹
❸
❽
1
2
3. Pneumatic components (when the pneumatic center guide is used)