Operation Manual

– 5 –
1) Pass the thread through thread slit
A
, and pull
the thread in direction
B
.
By so doing, the thread will pass under the ten-
sion spring and come out from notch
B
.
2) Check that the bobbin rotates in the direction of
the arrow when thread
C
is pulled.
B
C
A
8. ATTACHING THE NEEDLE
9. SETTING THE BOBBIN INTO THE BOBBIN CASE
10. ADJUSTING THE STITCH LENGTH
WARNING :
To protect against possible personal injury due to abrupt start of the machine, be sure to start the
following work after turning the power off and ascertaining that the motor is at rest.