Instructions

User Manual JUICE BOOSTER 2 [EL-JB2, EA-JB2] version 1.07 EN 21
13.5. Reducing the charge intensity
• Press the SELECT button before plugging the connector into the car or in the 30 seconds
afterwards. The green LED starts to flash indicating that the vehicle is ready to charge. Press
the SELECT button as many times as necessary until the LED is at the desired amperage.
Pressing the button again after position 6 A causes the LED to jump back to the maximum
value defined by the respective adapter in use.
Reducing the charge intensity is always recommended for old installations and continuous
operation. This may also be necessary if multiple e-cars are being charged at outlets that
share fuses or where the outlets are fused for and specifically state lower amp values.
13.6. Increasing the charge intensity
• The charging intensity emitted by the JUICE BOOSTER 2 can not be increased for safety
reasons.