Instructions

User Manual JUICE BOOSTER 2 [EL-JB2, EA-JB2] version 1.07 EN 19
• Connect the type 2 connector to the vehicle.
• The charging process will begin automatically at the detected, or manually reduced, charging
intensity (unless JUICE BOOSTER 2 detects an error).
• The push-button for selecting the charge intensity and charging mode can be pressed for up
to 30 seconds after the vehicle is plugged in. After that it will be disabled. It is then no longer
possible to change the charge intensity or charging mode while the JUICE BOOSTER 2 is
connected to the vehicle. Therefore, if someone disconnects the mains while the vehicle is
locked and then plugs it back in again, the charge intensity does not change, cannot be
changed manually and the JUICE BOOSTER 2 independently resumes the charging process.
The LED(s) Duration Process
Sequential flashing orange
(D)
permanent Charging in progress
A single LED lights up green permanent Indicates the charge intensity in amps
A single LED lights up green, NO
sequential flashing lights
permanent Charging has not yet started (e.g.
because charging has been scheduled
for a specific time) or it has been ended
by a proper signal from the vehicle.
All LEDs flashing red,
one individual red indicator at
(E)
flashing at
intervals
Error message. See Point 15
Individual red LEDs indicate the error
detected
* Standard mode is unsuitable for UK, France and Norway. For these countries
select a different mode (see Point 13.4)
WARNING
Fire hazard
Defective or incorrectly dimensioned cables, and/or defective or unauthorised fuse bridging can
result in fire or smouldering in the cable or the outlet.
Notes:
• During the charging process, regularly check the temperature of the power sockets and
cables. If they are hot, stop charging immediately. “Hot” is when you cannot keep your hand
around the cable or connector for more than 20 seconds.
• If the electrical installation is particularly old, it may make sense to select a power level below
the one suggested.
• If several cars are charging up simultaneously on the same fuse or if other devices are
connected, it is advisable to adjust the boxes so that the total amperage of all devices does
not exceed the tripping threshold of the load-breaker.