Installation Guide

Phoenix 1 Installation Guide
Juganu HQ
1 Yahadut Canada St., Or-Yehuda, Israel
Tel.: + 972-3-5310031
[e-mail]
WWW.JUGANU.COM
The Information provided herein is subject to change without prior notice by Juganu. Please
verify all details with Juganu. All values are typical values when measured under normal
laboratory conditions, and Juganu makes no warranties, expressed or implied, that such
performance will be obtained under end-use conditions.
JL-IG_Phoenix1 | Rev.03
2
Safety Instructions and Warnings
DANGER - Risk of Shock - Disconnect Power before Installation
FOLLOW THESE INSTRUCTIONS CAREFULLY TO
AVOID DAMAGE TO FIXTURE AND PERSONAL INJURY
- Installation must be performed by a certified licensed electrician in accordance with local law.
- Make sure the AC power grid functions properly, otherwise the internal driver may
be damaged.
- Visually inspect the fixture for visible cracks, missing screws, or exposed electrical
components.
- In case of fault, please bring the fixture to an accredited Juganu laboratory for repair.
Juganu has the right not to provide after-sales service if repair/maintenance was carried
out by a non-licensed/certified body for its products.
- The light fixture is designed for installation on a suitable Pole only.
- Do not remove the label of the fixture.
- Keep the light fixture away from extreme heat sources or flames.
Do not make or alter any open holes in an enclosure of wiring
or electrical components during installation.
CAUTION