Installation Instructions

TB
-10LED-WL-US
Wireless Trailer Parameter Table
Main parameters:
Transmitter input voltage: DC9-30V
Host Input Voltage (Charging Voltage): DC5V
Battery capacity: 18650, 3.7V, 2000MA power battery
Charging time: 3-4 hours
Dust and waterproof grade: IP65
Working temperature: - 20 - 50 degrees
Functions:
Turn on:
Shortly press the switch once, the power indicator shows the current power, and then it goes out after 5S.
Open the system at the same time. The system working indicator flashes.
Shut down:
When the system is turned on and off by pressing the switch at one time, the working indicator lights of the
system are off and enter the mode of dormancy and power saving.
Electricity Indicator:
Four indicator lights are green, green, yellow and red, full of electricity, and red lights will slow flashing
alarm at low power.
Coding:
Open any function at the transmitter first. In the startup state of the host terminal, press the switch 5S to
enter the alignment mode. The yellow indicator flashes. After receiving the signal, the yellow indicator
flashes slowly under 1 to successfully align the code and exits the alignment. If no transmission signal 30S
is received, the code will automatically exit.
Charge:
When the red light flashes and alarms, it is recommended to charge the battery. The main engine will not
work when charging.
Note 1:
One host can only pair one launch, and the next pair will automatically clear the previous data. When
leaving the factory, it has been paired well. Only when the transmitter or host is replaced, can it enter the
code operation.