User's Manual

JTECH UHF Desktop Transmitter Installation and Operation Guide 320115K Page 28
Function Description
Send All Call
Scroll Down *
Sends a page to all RapidCall vibe/tone, Glowster and CommPass
pagers. Press the # key to send the command. ‘Sending All Call’
appears in the display, indicating the command has been sent.
Alternately, this command can be sent by entering “9998#” at the
enter pager screen.
Range Test
Scroll Down *
This feature allows you to conduct a range test. A range test is
provided to verify the coverage area. Press # to turn on range test
mode. The PeopleAlert then asks for the pager ID number to be
used for the test. For example:
To use RapidCall vibration/tone pager number 12, press “12 #”.
To use RapidCall numeric pager number 12, press “12 * #”.
The Desktop Transmitter display will alternate between ‘Num (or
Vib) 12 Testing’ and ‘Enter Pager #’. The range test page will be
sent approximately every 15 seconds. To exit the range test mode,
press * #. This key sequence brings up the special function menu
for the range test feature and then turns if off. One pager at a time
can be used for range testing.
Search Mode?
Scroll Down *
This feature allows for Glowster and CommPass pagers to be
located in the coverage area. To activate, simply press the # key
at the Search prompt. Glowsters off the charging rack within the
coverage area will respond with a tone. Glowsters with Voice and
CommPass family pagers will respond with the appropriate voice
message. Touch any key to exit search mode.
Default # of
Vibes
Scroll Down *
This feature allows for alerts 1-9 to be selected for the standard
default alert for pages sent. This should always be set to a
number between 1 and 5, corresponding to Alerts 1 – 5 as defined
on Table 1. The factory default setting is 3.
Audible ON/OFF
Scroll Down *
This feature is used to turn ON or OFF the audible tone alerts as
well as the voice table ready alert. Glowsters or CommPass
family pagers must be off/out of the charger and not stacked to be
able to ‘hear’ this OTA programming change.
Out of Range
(OOR) ON/OFF
Scroll Down *
This feature is used to turn ON or OFF the out of range
transmissions at the transmitter. When OOR is active, the desktop
transmitter sends an OOR transmission every 7 seconds. If this
feature is active, a Glowster or CommPass pager will respond with
the appropriate OOR tone/voice response after missing more than
2 consecutive OOR transmissions. It is strongly recommended
that appropriate range testing be conducted in order to implement
the OOR feature properly.