User's Manual

22
Standard Program Settings
Factory Settings: Unless ordered otherwise, the
factory defaults are:
• Pick Up Period: = 40 seconds
• All Call: = Selected
• Remote Panel Setting = Expedite mode
• Number Of Vibrations = Single Vibration
• Transmit Power = 2 Watt (Maximum)
Pick Up Time Factory setting is 40 seconds. To program:
1. Press and hold the PROG on the Controller Panel for
2 seconds.
2. LED’s 1-7 will blink.
3. Press button 3.
4. The current setting will blink and the remaining LED’s will light.
Each button = its value X 10 seconds. For example, button 5=
50 seconds.
5. Set for 10-80 seconds by pressing buttons 1-8 as needed.
6. To return to the programming mode, press ALL CALL once.
7. To return to normal operation, press ALL CALL again.
ALL CALL When the ALL CALL button is pressed the Controller will
page all Pagers. The alert will be 4 short double vibrations
and then a short single vibration. To program:
1. Press and hold PROG button on the
Controller Panel for 2 seconds .
2. LED’s 1-7 will blink.
3. Press button 4.
4. A blinking LED indicates the current choice.
Button blinking 1 = ALL CALL ON
Button blinking 2 = ALL CALL OFF
5. Press button 1 to turn ALL CALL ON or button 2 to turn ALL
CALL OFF.
6. Press ALL CALL once to return to programming mode.
7. Press ALL CALL again to return to normal operation.
All Call Pick Up Time Factory Settings
Draft Copy