User's Manual

19
Paging using a Controller or Expeditor Panel
1. Press the number on the Controller or Expeditor Panel of the Pager you
want to page.
2. The light on the Panel, next to that number will turn ON.
3. The TRANSMIT light will turn ON for 2-3 seconds and turn off.
4. The Pager will receive a single, one second vibration (factory setting) or:
A. Send double or triple vibrations individually at any time by pressing 2X
or 3X button before
pressing the Pager button. The Controller must be
programmed for single vibration (factory setting) for these buttons to
work as described.
B. Send double or triple vibrations by changing the Controller settings. If
changed, it affects all Pagers used and the 2X and 3X buttons are
disabled.
5. The light on the panel, next to that Pager number, will continue to stay ON
for 40 seconds (factory setting).
6. If a Controller and Expeditor Panel are
combined, pressing a button on either
panel will light both panels.
7. After 40 seconds (factory setting), the
light next to the number pressed will
begin to blink on the Panel or Panels for
an additional 40 seconds (factory setting),
before turning off.
Paging the Managers Pager
1. Page the Managers Pager at any time by
pressing PROG on the Controller or
Expeditor/Cancel Panel.
2. The TRANSMIT light will turn ON for 2-3
seconds and turn off.
3. If paged from a Controller, the Managers
Pager will display “99”.
4. If paged from a Expeditor Panel, the
Managers Pager will display “98”.
5. If paged from a Managers Button, the
Managers Pager will display “00”.
Paging a Managers Pager Paging a Transmitter or Expeditor Panel
Draft Copy