User's Manual

18
Range Testing
When the Controller is put into
Range Test Mode, it will continue to
send a page every 3-4 seconds for 4
minutes. This will allow a person to
walk the area where your Pagers will
be used and check for dead spots or
weak signal areas. If you find such
areas, try relocating the Controller.
To set the Controller into Range Test Mode
1. Wear any Wait Staff Pager as usual, do not hold the Pager in your hands.
2. The Pager selected will vibrate during the range test.
3. Press and hold the program
button for 2 seconds.
4. LED’s 1-7 will light up.
5. Press button 6.
6. All LED’s and TRANSMIT will
blink.
7. Press the button, for the Pager
you are using.
8. The LED for that button will turn
on, all other buttons will blink.
9. TRANSMIT button will blink
every 3-4 seconds.
10. Move around the paging area,
the Pager worn will continue to
alert every 2-4 seconds while in
the range of the Controller.
Range Testing
Draft Copy