User's Manual

13
Group Paging using the telephone:
Group information can be preprogrammed into the Pagers at your Distributor’s site or
JTECH. “Dynamic” Groups can be programmed by the user.
1. Pick up the telephone and listen for the dial tone.
2. Dial the telephone number that has been assigned to the
Telco Module installed.
3. Listen for a voice message that confirms the Controller is ready.
4. Within 8-10 seconds, use the telephone keypad:
a. Press the * key.
b. Enter the Group number (1-99) to page.
c. Press the * key.
d. Enter a numeric message, if desired (16 digits maximum).
e. Press the # key to send the page.
5. A voice message heard on the phone verifies that the message was sent.
6. Hang up the telephone.