User's Manual
12
Connecting the TELCO (Telecommunications) Module for Phone connections.
1. Verify that a TELCO Module has been installed in your Controller.
The Module can be installed into any of the expansion slots except slot 6.
2. Connect the supplied RJ11 Cable to the TELCO Module and the
other end to a dedicated (analog) telephone line.
3. Up to 5 TELCO Modules can be installed to 5 different phone lines
if needed. Each one independently controlled.
Paging a single pager using the telephone:
1. Pick up the phone and listen for the dial tone.
2. Dial the phone number that has been assigned to the TELCO Module installed.
3. Listen for a voice message from the telephone that confirms the Controller is ready.
4. Within 8-10 seconds, use the telephone keypad:
a. Enter the Pager number (up to 4 digits).
b. Press the * key.
c. Enter a numeric message, if desired (16 digits maximum).
d. Press the # key to send the page.
5. A voice message heard on the phone confirms the message was sent.
6. Hang up the telephone.