User's Manual

(3) RESTTX Installation
Insert batteries properly when the option setup above is complete. Two 3.6V special
XENO batteries should be used, and the batteries last at least 1 year under the condition
of paging 20 times a day. Those batteries are not available to purchase in the local
markets.
A message “Startup Complete” will appear on each pager when the power is switched on.
(Ensure batteries have been properly installed if no message appears on pager displays.
Try to power off and on the unit again.)
Receiving the message “Startup complete” means the system is ready for operation.
Position and install the RESTTX unit on a desired place.
It is strongly recommended to avoid any running water, humidity, and hot temperature
when installing. These may cause the unit malfunctioning. Installing the unit outside the
restroom door or doorway is recommended.
3. OPERATION
1) CANCEL Button
When the counting reaches the pre-set use number, the unit transmit a message to a
pager.
A janitor or a staff holding the pager with transmitted message is required to go to
the restroom and push “Cancel” button.
Pushing the “Cancel” button only reset the count of the use. This function is to confirm
the facility checkup. With the manager option on, also a manager pager holder will get
a message when “Cancel” button is pushed.
RESTTX sends messages to pagers every 90 seconds but up to 3 times.
The count gets reset to 0 upon pushing “Cancel” button.
Note – Pushing and holding down the “Cancel” button for 3 seconds clears up the
count, and the red LED light turns on). Ensure the light turns on with an incoming
message.)
2) SERVICE Button
The “SERVICE” button is for a manager in charge of the facility. The manager pushes
the “SERVICE” button whenever a facility checkup is needed.
The red LED light turns on, and the unit pages a staff when the button is pushed and
held down for 3 seconds. When the facility checkup is done, the staff is required to