User's Manual

2.Placement&MountingInstructions
1)DESKTOP
Youcanuseyourtransmitterwiththe20degreewedgeattached or remove the
wedgeandlaythetransmitterflat.
2)WALLMOUNT
Tomountyourtransmitteronawall
Remove the plastic bracket (included) under the transmitter unit by
unlockingthe2latches
Placetheplasticbracketagainstthewallandwiththeaidofapencil,mark
the position of the mounting holes. (Refer to figure below) Mount the
transmitterinaconvenientlocationwhereapoweroutletisavailable.
Drillaholeonthemarketposition.Installthe3mountingscrews(anduse
anchorswherenecessary)Ensurethatthescrewsarenotfullytightenedso
thattheunitcanbeeasilyremovedfromthewall.
Placethetransmitterontothewall(withouttheplasticbracket)Plugthe2‐
ampwalltransformerintoanysuitableACoutlet.Plugthepowerconnector
intothepowerjackonthetoplefthandsideoftheunit.Transmitterisnow
readyforuse.Becertaintomountthetransmitterawayfromphones,heat,
moistureandexposedpowercircuits.Theseitemscandamageyoursystem
andshortentransmissionrange.
3)SYSTEMCONFIGURATION
Yoursystemwassetatthefactoryandwillfunctionassoonasitispoweredup.
Defaultsetupisasbelow:
Currenttime
SleepshutdownOFF
RangeTestOFF