Data Sheet

20
as a Part 15 digital device.
The host integrator installing this module into their product must ensure that the
final composite product complies with the FCC requirements by a technical
assessment or evaluation to the FCC rules, including the transmitter operation and
should refer to guidance in KDB 996369.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
This appliance and its antenna must not be co-located or operation in conjunction
with any other antenna or transmitter.
FCC CAUTION:
Any changes or modifications to the equipment not expressly approved by the
party responsible for compliance could void your authority to operate the
equipment.
FCC ID: WDC-J1901