User's Manual

“33” and “44” buttons instead of OPEN, BUS, CLEAR and EST buttons and the
buttons will be functioned as Predefined Messages
(3) Manager Pager
If “Manager Pager” is set on, 4 buttons are recognized as shortcuts of “Manager
No# 1”, “Manager No#2”, “Manager No#3” and “Manager No#4” buttons instead
of OPEN, BUS, CLEAR and EST buttons and the buttons will be functioned as
Predefined Messages
5) Set Pager Alert (Factory Default: Vibe Only)
With this feature, you have the option of changing the way your pagers alert the
guest.
Be sure that all pagers are returned before performing this procedure.
To change the alert mode of your pagers follow these instructions
 Remove all the pagers from the charger base or unplug the power supply
that is connected to the charger bases.
 At the “Set Pager Alert” menu, press the “#” key to scroll through the
different alert options.
 After making a selection, press the “ENTER” key 3 times. After sending the
code, the pagers will now respond with your new selection.
 Press “CANCEL” key to exit the system programming menu.
 Return all the pagers to the charger base or plug the power supply. The
pagers are ready to receive the page with the new alert.
6) Duty Alert (Factory Default: OFF)
This feature enables your transmitter to send a page, at a preset time, to a certain
pager to remind them of a duty required of them. For example, a buzzer can receive
a page every 60 minutes to remind him to check the restrooms.
You can assign up to 3 different pagers to be duty alert pagers.
Programming the duty alert
 At the “Duty Alert” menu, “Duty Pager(1-3) is displayed and you can select
Duty Pager # among up to 3.
 Select Duty Pager # using “#” key and press “ENTER” key.
 If you choose Duty Pager #1, then “Duty Pager #1: OFF” is displayed.
 You can select ON/OFF using “#” key and then press “ENTER” key.
 You can setup Duty Pager #2 and #3 as same way as Duty Pager #1