User's Manual

display. If the time is not correct, press the “CANCEL” key twice to exit the
system programming menu,
3) Range Test (Factory Default: OFF)
With this feature, you can determine what distance your transmitter will cover.
 Remove a couple of pagers from the charger base.
 At the range test menu, press “#” key to turn range test “ON”
 Press “ENTER” to start the range test. As soon as range test is activated,
you’ll notice the IQ pagers flash once every 10 seconds. Walk around your
property. When you reach the point where the pagers do not flash
consistently, this is your maximum range. We can walk you through changing
the power level of your transmitter.
 Press the “CANCEL” key to stop the range test. Press the “CANCEL” key again
to exit the system programming menu.
4) Button Select (Factory Default: Function)
With this feature, you can select button function type.
(1) Open Table
If “Open Table” is set, “OPEN”, “BUS”, “CLEAR” and “EST” keys are available.
- OPEN, BUS, CLEAR: These buttons will display Table Status.
- EST: This button will setup Estimated Waiting Time.
(2) Preset Message
① Beep
If “Beep” is set on, 4 buttons are recognized as “F1”, “F2”, “F3” and “F4” buttons
instead of OPEN, BUS, CLEAR and EST buttons and the buttons will be functioned
as Predefined Messages
② Num Code
If “Number Code” is set on, 4 buttons are recognized as, for example, “11”, “22”,