User's Manual

3
4
Parts Included with Camera
- 2.4 GHz Single Channel Wireless Color Weather-proof Camera
- Camera Stand
- 10V AC/DC adaptor for the Camera
Parts of The System
Parts of the Camera
1. Camera lens
2.Antenna
3.Power Cable
4. Camera Stand
5. Camera Cover Shield
Installation
Tools you will need: Pencil, Drill, drill Bits, Phillips-head Screwdriver, Hammer
Installing Mounting Bracket (Camera Stand)
1. Select a mouniting location. Use the mounting bracket as a guide and mark the screw holes
with a pencile.
2. Drill 1/8" pilot holes over the center of each pencil mark. For mounting on drywall or sheet
rock, use the wall anchors provided. Gently tap the anchors into the pilot holes with hammer
until they are flush.
3. Align the bracket over the holes or wall anchors and tighten the screw to secure the bracket
to the wall or ceiling.
1.
2.
3.
4.
Installing the Wireless Color Weather-proof Camera
To install the system, follow these steps:
Weather-proof Camera:
1. Plug the AC/DC adapter cord into the power input jack on the bottom of power cable.
2. Water-proof camera power will auto on when you plug the AC/DC adapter into a standard (110V-240V)
AC outlet.
3. Before system operated, the receiver channel should be selected the same channel as the channel sticker
shown on the camera body.
Wireless Camera Specification:
Weather-proof camera:
Image sensor 1/3'' Color CMOS IMAGE SENSOR
Resolution 330 Horizontal TV Lines
Lens 6mm
Illumination 0.2 Lux
Power Consumption 12V DC, 300mA
1.3 Watts
Operating TEMP. 32' F - 122'F
0'C - 50'C
Dimentions 100x95x40mm (approx)
Channel Frequency Either 2412 or/ 2442 or/ 2472