Installation Guide

ManualsBrandsJSG Oceana ManualsKitchenUndermount Glass 16.5 in. 0-Hole Kitchen Sink in Champagne Gold

Product Features

15¾” x 14⅛”

8⅛” deep basin

Single compartment

Undercounter or drop-in

Drain width 3½”

Centered drain hole

Rim width 1¼”

Glass thickness at drain ½”

Template provided

Cabinet cradle installation recommended.

Codes/Standards Applicable

Specified model meets or exceeds the following:

IAMPO/UPC

Canadian Standards Association (CSA)

KITCHEN SINK MODEL #009-XXX-XXX

MODEL DESCRIPTION COLORS

009-009-(XXX) KITCHEN SINK UNDERMOUNT 17 COLORS

009-008-(XXX) KITCHEN SINK DROP-IN 17 COLORS

Specified Model

Lustre Colors Premium Colors Precious Metals

Crystal - 000 White Smoke - 011 24 Gold - 400

Crystal Reflections - 300 Pewter - 021 Platinum - 500

Champagne Gold - 100 Steel Gray - 244

Gold Reflections - 101 Slate Blue Reflections - 344

Sea Green - 200 Teal - 020

Green Reflections - 201 Pearl - 330

Black Nickel - 022 Blue Reflections - 140

Copper - 010

Colors

Product Specification:

The kitchen sink shall be 15¾” length, and 14⅛” width. Sink shall be made of JSG Oceana

“Hard Roc” glass. Sink shall be a single compartment. Sink shall include a stainless steel #305

basket. Sink shall be known as Model #009-XXX-XXX.

Summary of content (4 pages)

PAGE 1
KITCHEN SINK MODEL #009-XXX-XXX Product Features 15¾” x 14⅛” 8⅛” deep basin Single compartment Undercounter or drop-in Drain width 3½” Centered drain hole Rim width 1¼” Glass thickness at drain ½” Template provided Cabinet cradle installation recommended.
PAGE 2
KITCHEN SINK MODEL #009-XXX-XXX Product Information Fixture*: basin area water depth Sink 15¾” x 14⅛” 8⅝” Outlet 3½” D *Approximate measurements for comparison only. 15 3/4” 18 1/8” Included Components: Stainless Steel #305 Basket Cutout template Top rim: 1¼” Underneath rim: ⅝” 14 1/8” Countertop 16 1/2” Silicone Sink Foam bumpers Clip (not included) Allow 2” minimum for clearance around sink rim for clip attachment.
PAGE 3
KITCHEN SINK MODEL #009-009-XXX Undermount Installation Instructions JSG Oceana Undermount kitchen sinks are recommended to be installed with a negative reveal. (see diagram). Negative Reveal - The countertop must extend over the edge of the sink on all sides by approximately ¼”. Templates are supplied only as a guide. The physical use of the sink will assure a more accurate cutout. The instructions that follow are for installing a JSG Oceana undermount glass sink in a solid surface countertop only.
PAGE 4
KITCHEN SINK MODEL #009-009-XXX 2. Cut the Sink Mounting Hole ! (Recommended for profession installers only.) CAUTION: RISK OF PRODUCT DAMAGE. To avoid damage to the sink, do not cut, drill, or sand the countertop while it is in position over the sink. Make the sink cutout. Find the center of the sink template and align it with the center mark drawn on the countertop. Place the template with the front edge along the front edge line drawn on the countertop.