Specifications Sheet

VESSEL SINK MODEL #005-012-XXX
Fixture* basin area water depth
Sink 17” to 20” 3.5” to 6.5”
Drain 1¾”
Product Information & Diagram
*Approximate measurements for comparison only.
Scratch Resistant•Stain Resistant•Thermal Shock Resistant•IAPMO Certified & UPC Approved
1 ¾” drain hole
JSG Oceana recommends that Vessel sinks and routering of your solid surface material should be installed
by a professional installer for best results.
The physical use of the sink will assure a more accurate cutout.
The instructions that follow are for installing a JSG Oceana Vessel glass sink on top of a solid surface countertop
only. Minimum thickness of the actual countertop is 1/2”.
Requirements vary for installation in a granite, marble, stone or synthetic countertop. Please contact your fabri-
cator for specific details.
Before installing, inspect the sink for damage. Do not install a damaged unit. No returns accepted after
installation, unless product is mechanically defected. Store the sink in the protective carton whenever pos-
sible.
Remember, it is your responsibility to follow all local plumbing and building codes.
The warranty will be voided if these installation instructions are not followed.
Vessel Installation Instructions
Rubber washer
Nut
Threaded
tailpipe
 Drill a hole in countertop slightly larger than the width of your drain.
(no less than 1 3/8” and no larger than 1 1/2”).
 Place a rubber washer and/or apply a thin bead of caulking between
vessel and countertop as a buffer.
 Apply thin layer of plumber’s putty under rim of drain and place into
sink. Drain will go through vessel and hole in countertop.
 Hand tighten drain underneath countertop. DO NOT OVERTIGHTEN.
 If the drain does not have enough threads to tighten completely up to
the countertop, purchase a piece of PVC pipe to make-up the difference.
Use two rubber washers to seal the PVC pipe and prevent leakage.
(PVC pipe can also be used if you purchase a drain with an overflow
hole.)
 Clear caulking or epoxy can also be applied between vessel and coun-
tertop for added stability.
JSG Oceana Alina Art Vessel
215 North 4
th
Street, Jeannette, PA 15644 ph:724.523.5567 fax:[phone] www.jsgoceana.com
Made in the U.S.A.
4” to 7”
17” to 20”
3.5” to 6.5” depth